LP3933SLX National Semiconductor, LP3933SLX Datasheet - Page 6

• Manufacturer Part Number: LP3933SLX
• Description: IC LED DRVR WT/RGB BCKLGT 32TCSP
• Manufacturer: National Semiconductor
• Type: Backlight, White LED, RGB (Serial Interface)r

Specifications of LP3933SLX

• Constant Current: Yes
• Topology: PWM, Step-Up (Boost)
• Number Of Outputs: 12
• Internal Driver: Yes
• Type - Primary: Backlight, Flash/Torch, LED Blinker, Light Management Unit (LMU)
• Type - Secondary: RGB, White LED
• Frequency: 1MHz
• Voltage - Supply: 2.65 V ~ 2.9 V
• Voltage - Output: 5.3V
• Mounting Type: Surface Mount
• Package / Case: 32-Laminate TCSP
• Operating Temperature: -40°C ~ 85°C
• Current - Output / Channel: 120mA
• Internal Switch(s): Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Efficiency: -

www.national.com
Modes of Operation
RESET:
STANDBY:
STARTUP:
BOOST STARTUP: Soft start for boost output is generated in the BOOST STARTUP mode. In this mode the boost output is
NORMAL:
In the RESET mode all the internal registers are reset to the default values (Boost output register 3Fh
(5.0V), all other registers 00h). Reset is entered always if input NRST is LOW or internal Power On Reset
is active.
The STANDBY mode is entered if the register bit NSTBY is LOW and Reset is not active. This is the low
power consumption mode, when all circuit functions are disabled. Registers can be written in this mode and
the control bits are effective immediately after start up.
INTERNAL STARTUP SEQUENCE powers up all the needed internal blocks (V
To ensure the correct oscillator initialization, a 10 ms delay is generated by the internal state-machine.
Thermal shutdown (THSD) disables the chip operation and Startup mode is entered until no thermal
shutdown event is present.
raised in PFM mode during the 10 ms delay generated by the state-machine. The Boost startup is entered
from Internal Startup Sequence if EN_BOOST is HIGH or from Normal mode when EN_BOOST is written
HIGH.
During NORMAL mode the user controls the chip using the Control Registers. The registers can be written
in any sequence and any number of bits can be altered in a register in one write.
6
20080525
REF
, Bias, Oscillator etc.).