ST662ACD-TR STMicroelectronics, ST662ACD-TR Datasheet - Page 11

• Manufacturer Part Number: ST662ACD-TR
• Description: IC CONV DC-DC 0.03A FLASH 8-SOIC
• Manufacturer: STMicroelectronics
• Type: Switched Capacitor (Charge Pump)r

Specifications of ST662ACD-TR

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 11.4 ~ 12.6 V
• Current - Output: 30mA
• Frequency - Switching: 400kHz
• Voltage - Input: 4.5 ~ 5.5 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Power - Output: 500mW
• Output Voltage: 12 V
• Output Current: 30 mA
• Output Power: 500 mW
• Input Voltage: 4.5 V to 5.5 V
• Switching Frequency: 400 KHz
• Operating Temperature Range: - 40 C to + 125 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6542-2; ST662ACD-TR

ST662AB, ST662AC
7
Figure 15. KIT layout
Application circuit
Based on fast charge/discharge of capacitors, this circuit involves high di/dt values limited
only by R
inductive paths and place capacitors as close as possible to the device.
A good layout design is strongly recommended for noise reason. For best performance, use
very short connections to the capacitors and the values shown in
C3 and C4 must have low ESR in order to minimize the output ripple. Their values can be
reduced to 2 µF and 1 µF, respectively, when using ceramic capacitors, but must be of 10 µF
or larger if aluminium electrolytic are chosen.
C5 must be placed as close to the device as possible and could be omitted if very low output
noise performance are not required.
Figure 15
ON
and
of switches. This implies a critical layout design due to the need to minimize
Figure 16
show, respectively, our EVALUATION kit layout and the relatively.
Doc ID 5068 Rev 8
Table
7.
Application circuit
11/20