KP-FSD2 Panduit Corp, KP-FSD2 Datasheet - Page 554

• Manufacturer Part Number: KP-FSD2
• Description: KIT FERRULE INS DIN AWG22-14
• Manufacturer: Panduit Corp
• Series: Pan-Term®r
• Type: Ferrule Kitr

Specifications of KP-FSD2

• Kit Type: Ferrule - Wire End
• Values: 400 pcs - Assorted Insulated 22 ~ 14 AWG Ferrules
• Where Used: To terminate stranded wire for insertion into terminal blocks
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Management
Identification
Accessories
Connectors
Connectors
& Write-On
Protection
Grounding
Pre-Printed
Cable Ties
Terminals
Permanent
Solutions
Overview
Steel Ties
Lockout/
& Safety
Stainless
Raceway
Abrasion
Labeling
Systems
Markers
Tagout
System
Surface
Wiring
Power
Labels
Index
Cable
Cable
D1.82
Duct
E5.
B1.
B2.
B3.
C1.
C2.
C3.
C4.
D1.
D2.
D3.
E1.
E2.
E3.
E4.
A.
F.
Crimping Guidelines for Panduit
Splices and Wire Joints (continued)
Insulated and Non-Insulated Wire Joints
A. Properly strip wires per manufacturer’s
B. Twist stripped wire ends together and insert wires into
C. Locate wire joint in appropriate wire gauge crimp die
D. Squeeze tool handles firmly to perform the electrical
Note: An insulation crimp is not required on an insulated
NOTES for Crimping with the Preferred Hand Operated Controlled Cycle Crimping Tools:
1. Panduit controlled cycle crimping tools properly locate rings, forks, and barrel insulated disconnects, pins, and blades. No
2. When using the preferred controlled cycle tool, once a crimp has been started, the ratchet device of controlled cycle
3. Controlled cycle tools provide the electrical crimp and the insulation closure in a single cycle of the tool.
4. When using controlled cycle tooling, insulated butt splices must be inserted from the back of the tool to ensure that the
5. Perform the electrical crimp using the preferred
A. Make sure the terminal barrel is centered correctly in the
B. Determine the correct die pocket to use based on the color
C. Squeeze the handles of the tool until one click is heard;
D. Insert the wire and complete cycle to perform the electrical
E. Crimp is complete.
Bent Back Strands
6. Inspect the crimp
Note: If your crimp looks like any of the examples shown
Order number of pieces required, in multiples of Standard Package Quantity.
recommendations on product package label.
wire joint.
pocket and position crimp in the center of the
metal insert.
crimp. (See Note 2 below)
further positioning is required.
tools will not release until the crimp is complete, independent of operator expertise.
electrical and insulation closure crimp pockets are properly aligned with the splice.
controlled cycle tool
right die pocket by using the product locator on the
backside of the tool.
code of the terminal.
this click indicates the terminal is now held in place
securely to insert the wire.
and insulation crimp simultaneously.
wire joint.
below, cut off the terminal and re-crimp. These crimps
would provide a poor connection!
Over Crimp
Rotated Crimp
ELECTRICAL SOLUTIONS
®
Pan-Term
Steps A and B
Step A
®
Terminals, Disconnects,
Step D
Steps C and D
Step B
Complete Crimp
Prime items appear in BOLD.
Complete Crimp
Step C