SDCFJ-256-388-03 SanDisk, SDCFJ-256-388-03 Datasheet - Page 11
![COMPACT FLASH 256MB](/photos/7/83/78343/mfg_sdcfj_series_sml.jpg)
SDCFJ-256-388-03
Manufacturer Part Number
SDCFJ-256-388-03
Description
COMPACT FLASH 256MB
Manufacturer
SanDisk
Type
CompactFlashr
Specifications of SDCFJ-256-388-03
Memory Size
256MB
Memory Type
CompactFLASH
Density
256MByte
Operating Supply Voltage (typ)
3.3/5V
Operating Temperature (min)
0C
Operating Temperature (max)
70C
Package Type
CF
Mounting
Socket
Pin Count
50
Operating Temperature Classification
Commercial
Operating Supply Voltage (min)
3.135/4.5V
Operating Supply Voltage (max)
3.465/5.5V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
© 2007 SanDisk Corporation
SanDisk CompactFlash Card OEM Product Manual
1.7.5
1.7.6
1.7.7
Automatic Sleep Mode
A unique feature of the SanDisk CompactFlash Memory Card is automatic entrance and exit
from sleep mode. Upon completion of a command, the card will enter sleep mode to conserve
power if no further commands are received within 5 msec. The host does not have to take any
action for this to occur. In most systems, the CompactFlash Memory Card is in sleep mode
except when the host is accessing it, thus conserving power. The delay from command
completion to entering sleep mode is adjustable.
When the host is ready to access the card and is in sleep mode, any command issued to it will
cause the card to exit sleep and respond. The host does not have to follow the ATA protocol of
issuing a reset first. It may do this if desired, but it is not needed. By not issuing the reset,
performance is improved through the reduction of overhead but this must be done only for the
SanDisk products as other ATA products may not support this feature.
Dynamic Adjustment of Performance vs. Power Consumption
This feature is no longer supported. This command will be treated as a NOP (No Operation) to
guarantee backward compatibility.
Power Supply Requirements
This is a dual voltage product, which means it will operate at a voltage range of 3.30 volts ±
5% or 5.00 volts ± 10%. Per the PCMCIA specification Section 2.1.1, the host system must
apply 0 volts in order to change a voltage range. This same procedure of providing 0 volts to
the card is required if the host system applies an input voltage outside the desired voltage by
more than 15%. This means less than 4.25 volts for the 5.00-volt range and less than 2.75 volts
for the 3.30 volt range.
1-5
Rev. 12.0, 02/07
Introduction