ISC01P NKK Switches, ISC01P Datasheet - Page 6

• Manufacturer Part Number: ISC01P
• Description: DISPLAY OLED 52RGB X 36
• Manufacturer: NKK Switches
• Series: SmartDisplay™r

Specifications of ISC01P

• Mfg Application Notes: OLED SmartSwitch/Display Appl Notes
• Display Type: OLED, Color
• Display Mode: Passive
• Viewing Area: 12.9mm L x 9.9mm W
• Backlight: LED - Red/Green/Blue
• Dot Size: 0.21mm W x 0.22mm H
• Dot Pixels: 52 x 36
• Interface: Serial
• Pixel Density: 52 x 36
• Viewing Area (w X H): 12.9 mm x 9.9 mm
• Operating Voltage: 2.8 V
• Operating Current: 2.4 mA
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 20 C
• Viewing Angle: 180 deg
• For Use With: IS-INT DEV KIT-7D - SMARTSWITCH INT DEVELOPMNT KIT7D360-2340 - KIT DEV FOR OLED DISPLAY
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Dot Pitch: -
• Lead Free Status / Rohs Status: Compliant
• Other names: 360-2342

OLED Display
PRECAUTIONS FOR HANDLING & STORAGE OF OLED DEVICES
Handling
1. The IS Series OLED devices are electrostatic sensitive. To avoid damage to IC, do not touch terminals unless
2. Signal input under conditions not recommended may cause damage to the OLED unit or deterioration of the
3. If the OLED panel is broken, avoid touching the contents. Wash off any contact to the skin or clothing.
4. Limit operating force to switch keytop to 100.0N maximum, as excessive pressure may damage the OLED.
5. For OLED display, it is necessary for bracket legs to be Grounded.
6. Recommended soldering time and temperature limits for OLED switch or display:
7. The IS series OLED devices are not process sealed.
8. Pixels acquire diminished brightness over time and use, and those most frequently habituated have greater
9. For switch, clean cap surface with dry cloth. If further cleaning is needed, wipe with dampened cloth using
Storage
1. Store in original container and away from direct sunlight.
2. Keep away from static electricity.
3. Avoid extreme temperatures, high humidity, gaseous substances, and all forms of chemical contamination.
properly isolated from static electricity.
display. Follow directions regarding supply sequences of power and signal voltages.
Wave Soldering: see Profile A in Supplement section.
Manual Soldering: see Profile A in Supplement section.
A
reduction of brightness than those less used. To minimize this difference, operate OLED unit so that all pixels
are used as consistently as possible.
neutral cleanser and dry with clean cloth. Do not use organic solvent. For display, avoid contact with any
flux or detergent. If any liquids spill on display surface, immediately wipe with soft absorbent cloth.
void temperatures exceeding 80°C at the OLED.
www.nkk.com
SmartSwitch
SENSITIVE DEVICES
ELECTROSTATIC
ATTENTION
TM
E7
E