T-51378L025J-FW-P-AA Optrex America Inc, T-51378L025J-FW-P-AA Datasheet - Page 22
![no-image](/images/no-image-200.jpg)
T-51378L025J-FW-P-AA
Manufacturer Part Number
T-51378L025J-FW-P-AA
Description
LCD 2.5" TFT MODULE NTSC/PAL
Manufacturer
Optrex America Inc
Datasheet
1.T-51378L025J-FW-P-AA.pdf
(24 pages)
Specifications of T-51378L025J-FW-P-AA
Display Type
TFT - Color LCD
Viewing Area
50.20mm L x 37.70mm W
Dot Pitch
0.16mm x 0.11mm
Dot Pixels
480 x 234
Interface
-
Backlight
-
Display Mode
-
Dot Size
-
Other names
73-1213
11. Handling Cautions
11-1) Mounting of module
11-2) Precautions in mounting
11-3) Adjusting module
11-4) Others
a) Please power off the module when you connect the input/output
connector.
b) Please connect the ground pattern of the inverter circuit surely. If the
a) When metal part of the TFT-LCD module (shielding lid and rear case) is
b) Wipe off water drops or finger grease immediately. Long contact with
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or
d) Since CMOS LSI is used in the module. So take care of static electricity
a) Adjusting volumes on the rear face of the module have been set optimally
b) Therefore, do not change any adjusted values. If adjusted values are
a) Do not expose the module to direct sunlight or intensive ultraviolet rays
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the
e) Observe all other precautionary requirements in handling general
f) Please adjust the voltage of common electrode as material of attachment
c) Polarizer which is made of soft material and susceptible to flaw must be
d) Protective film (Laminator) is applied on surface to protect it against
T-51378L025J-FW-P-AA
1.The noise from the backlight unit will increase.
2.The output from inverter circuit will be unstable.
3.In some cases a part of module will heat.
soiled, wipe it with soft dry cloth.
water may cause discoloration or spots.
bumped on hard surface. Please handle with care.
and earth yourself when handling.
before shipment.
changed, the specifications described may not be satisfied.
for many Hours.
because of leakage current from approach conductor by to draw lump
read lead line around.
panel. Avoid putting it into eyes or mouth. When liquid crystal sticks on
hands, clothes or feet. Wash it out immediately with soap.
electronic components.
by 1 module.
connection is not perfect, some following problems may happen possibly.
handled carefully.
scratches and dirt. It is recommended to peel off the laminator before
use and taking care of static electricity.
OPTREX CORPORATION
Page 22/24