LTL-307EE Lite-On Electronics, LTL-307EE Datasheet
LTL-307EE
Specifications of LTL-307EE
LTL-307EE
Available stocks
Related parts for LTL-307EE
LTL-307EE Summary of contents
Page 1
... All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25mm(.010") unless otherwise noted. 3. Protruded resin under flange is 1.0mm(.04") max. 4. Lead spacing is measured where the leads emerge from the package. 5. Specifications are subject to change without notice. Part No. : LTL-307EE BNS-OD-C131/ Lens Red Transparent Source Color Hi ...
Page 2
... Duty Cycle, 0.1ms Pulse Width) Continuous Forward Current Derating Linear From 50 ℃ Reverse Voltage Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [1.6mm(.063") From Body] Part No. : LTL-307EE BNS-OD-C131/ =25 ℃ A Maximum Rating -55 ℃ 100 ℃ -55 ℃ 100 ℃ 260 ℃ for 5 Seconds ...
Page 3
... International De L'Eclairage) eye-response curve. 2. θ is the off-axis angle at which the luminous intensity is half the axial luminous intensity. 1/2 3. The dominant wavelength, λ wavelength which defines the color of the device. 4. The Iv guarantee should be added ± 15% . Part No. : LTL-307EE BNS-OD-C131/ =25 ℃ A Symbol Min. ...
Page 4
... LITE-ON TECHNOLOGY CORPORATION Typical Electrical / Optical Characteristics Curves (25 ℃ Ambient Temperature Unless Otherwise Noted) Part No. : LTL-307EE BNS-OD-C131/ Page : ...
Page 5
... Soldering time 3 sec. Max. (one time only) Note: Excessive soldering temperature and/or time might result in deformation of the LED lens or catastrophic failure of the LED. IR reflow is not suitable process for through hole type LED lamp product. Part No. : LTL-307EE BNS-OD-C131/ CAUTIONS Wave soldering Pre-heat ...
Page 6
... To verify for ESD damage, check for “light up” and Vf of the suspect LEDs at low currents. The Vf of “good” LEDs should be >2.0V@0.1mA for InGaN product and >1.4V@0.1mA for AlInGaP product. Part No. : LTL-307EE BNS-OD-C131/ Circuit model B ...
Page 7
...