GS-R24FV0001.8 STMicroelectronics, GS-R24FV0001.8 Datasheet - Page 7

• Manufacturer Part Number: GS-R24FV0001.8
• Description: CONVERTR MODULE DC-DC 1.8A 15SIP
• Manufacturer: STMicroelectronics
• Series: GS-R24FPr
• Type: Point of Load (POL) Non-Isolatedr

Specifications of GS-R24FV0001.8

• Output: 1.235 ~ 5.5V
• Number Of Outputs: 1
• Power (watts): 10W
• Mounting Type: Through Hole
• Voltage - Input: 16 ~ 35V
• Package / Case: 10-SIP Module
• 1st Output: 1.235 ~ 5.5 VDC @ 1.8A
• Size / Dimension: 1.52" L x 0.18" W x 0.50" H (38.7mm x 4.5mm x 12.7mm)
• Power (watts) - Rated: 10W
• Operating Temperature: -25°C ~ 85°C
• Efficiency: 83%
• Output Current: 1.8A
• Screening Level: Commercial
• Operating Temperature Min Deg. C: -25C
• Operating Temperature Max Deg. C: 85C
• Product Height (mm): 12.7mm
• Mounting Style: Through Hole
• Pin Count: 10
• Output Voltage: 1.235 V to 5.5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Lead Free Status / Rohs Status: Compliant
• Other names: 497-8256

GS-R24F
4.6
4.7
4.8
Thermal shutdown
Output voltage programming (GS-R24F0002.0 and GS-
Loop compensation (GS-R24F0002.0 and GS-R24F0001.0)
The shutdown block generates a signal that turns off the power stage if the temperature of
the internal chip goes higher than a fixed internal threshold (150°C min).
The sensing element of the chip is very close to the PDMOS area, so ensuring an accurate
and fast temperature detection.
An hysteresis of approximately 20 °C avoids that the devices turns on and off continuously.
R24F0001.0)
The GS-R24F0002.0 output voltage is 5.54 V ±4 %, the GS-R24F0001.0 output voltage is
24.44 V ±4 %, to reduce these values connect a resistor between pin 11 (FB) and pin 10
(V
The resistor must be located very close to the proper pins, to minimize the injected noise
(see figure 2).
The resistor value is calculated using the following formula:
for GS-R24F0002.0 Rv = [(V
for GS-R24F0001.0 Rv = [(V
V
If required by particular load conditions, it is possible to change the feedback loop
compensation, adding an external capacitor between pin 11 (FB) and pin 10 (V
will act as speed up (see
out
out
can be adjusted between 1.235 V (Rv = 0 Ω) and 5.54 V/24.44 V (Rv = open).
).
Figure
out
out
- 1.235) * 11.3] / (5.54 - V
- 1.235) * 62] / (24.44 - V
4).
out
out
) --[kΩ].
) --[kΩ];
Application information
out
), which
7/13