S82Y-J01K FOR S82J-10W Omron, S82Y-J01K FOR S82J-10W Datasheet - Page 13

• Manufacturer Part Number: S82Y-J01K FOR S82J-10W
• Description: COVER FOR S82J-10W
• Manufacturer: Omron
• Series: S82Jr

Specifications of S82Y-J01K FOR S82J-10W

• Accessory Type: Cover
• For Use With/related Products: S82J 10W Power Supplies
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: S82Y-J01KFORS82J-10W; S82YJ01KFORS82J10W

If operation amplifiers as loads are connected in series, connect a diode between the positive and negative output terminals of each
Switching Power Supplies as shown in the illustration below. Without these diodes, the Power Supplies may not start when power is
turned on, possibly damaging internal circuits over a period of time.
Use Schottky barrier diodes with a low forward voltage (V
Guidelines for the dielectric strength and current of the diodes are as follows:
Dielectric strength: At least twice the rated output voltage of the Power Supply
Forward current:
No diodes are required for models that allow series operation.
J SERIES OPERATION
Only models with power ratings of 50/100/150/300/600 W allow series operation.
As shown in the following diagram, the output voltage from each Switching Power Supply can be added.
With the S82J-050jjjj or S82J-10024jj, if the load is shorted a reverse voltage may result in the Power Supply causing deteriora-
tion and damage. It is recommended that diodes are connected as shown in the previous diagram (D
J PARALLEL OPERATION
Only 300- and 600-W models can be in parallel operation. Do not operate any other models in parallel. The output of the models in paral-
lel operation is a maximum of 80% of the rated output.
Set the parallel operation selector to PARALLEL if the Units are in parallel operation and make sure that the thickness and the length of all
wires connected to the load are the same to ensure that the wires will have no voltage drop differences.
J GENERATING OUTPUT VOLTAGE (
An output of
13
±
INPUT
INPUT
Switching Power Supply
can be generated by using two power supplies as shown below, because the power supply produces a floating output.
INPUT
INPUT
INPUT
INPUT
At least twice the rated output current
+V
–V
+V
–V
INPUT
INPUT
+ V
– V
+ V
– V
+ V
– V
+ V
– V
+V
–V
+V
–V
D
D
2
1
D
Load
Load
D
1
2
S82J
Load
Load
±
F
). Other types of diodes will not be effective.
)
Load
Load
1
, D
2
).