GP485A TDK Corporation, GP485A Datasheet - Page 8

• Manufacturer Part Number: GP485A
• Description: GPIB CONTROLLER
• Manufacturer: TDK Corporation
• Series: ZUPr

Specifications of GP485A

• Accessory Type: Controller
• For Use With/related Products: ZUP Series
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4846340

3.1
This chapter contains instructions for initial inspection, preparation for use and repackaging for
shipment.
Connection to PC and Zup power supplies is described in Par. 3.7 ~ 3.11.
3.2 INITIAL INSPECTION
Prior to shipment the GP485 was inspected and found free of mechanical or electrical defects. Upon
unpacking of the GP485, inspect for any damage which may have occurred in transit. Keep all packing
materials until inspection has been completed. If any damage is detected, file a claim with the carrier
immediately and notify the Nemic-Lambda sales or service facility nearest you.
3.2.1 Mechanical inspection
The mechanical inspection should confirm that there is no exterior damage to the GP485 such as
broken connectors and front panel are not scratched or cracked.
3.2.2 Preparation for use
In order to be operational, the GP485 must be connected to an appropriate AC source. The line voltage
must be within the GP485 specification. DO NOT apply power before reading paragraph 3.2.3
3.2.3 AC Source requirements
The GP485 can be operated from a nominal 100V to 240V, single phase, 47 ~ 63Hz. The input voltage
range and current required is specified in chapter 2. Make sure that the AC voltage does not fall below
“low limit” specifications.
3.3 COOLING AND PLACEMENT
install the GP485 adjacent to a hot surface or heat generating equipment.
3.4 RACK MOUNTING
3.5 REPACKAGING FOR SHIPMENT
GP485 can be mounted in a standard 19” rack (3U height) and occupy 1/6 rack length. The GP485
should be fixed by M4 screws replacing the rubber feet on the bottom of the GP485. Screws must not
protrude more than 6mm into the unit. Refer to the outline drawing in this chapter for mounting details.
To ensure safe transportation of the instrument, it is recommended to use the original package. The
original packaging material is reusable. If the original package is not available, contact the Nemic-
Lambda Sales or service facility near you for details on obtaining suitable packaging and shipping
information. Please attach a tag to the GP485 unit describing the problem and specifying the owner,
model number and serial number of the unit.
The GP485 should be used in an area where the ambient temperature does not exceed +50 C. Do not
CHAPTER 3 INSTALLATION AND CONFIGURATION
GENERAL
operation of other instruments. If your equipment is susceptible to magnetic fields,
GP485 generates a magnetic field which might affect the
do not position adjacent to the GP485.
NOTE
O