122-28176 Parallax Inc, 122-28176 Datasheet - Page 157

• Manufacturer Part Number: 122-28176
• Description: GUIDE STUDENT PROCESS CONTROL
• Manufacturer: Parallax Inc

Specifications of 122-28176

• Accessory Type: Manual
• Product: Microcontroller Accessories
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Propeller Education (PE) Kit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

off quickly in code is not very efficient in that time is wasted looping and performing
other code. The 20% drive is not truly 20%.
Program Discussion
In the
speed and used to calibrate for the maximum speed.
!REQD
window and takes the form of:
!REQD initial value, time to display in seconds, message
An example string received from the BASIC Stamp would be:
\n
In this example, the initial value is 0 (false), display for 30 seconds, and the message
shows the current RPM. The
data and then test the user's response.
A transfer function is used to scale the RPM, or counts, to a percentage in the
DO...LOOP
output and dividing by the maximum input. Transfer functions are covered in greater
detail in Chapter 6.
In this case, the change in output is 0 to 100% and the change in input is 0 to the
maximum counts for the fan at maximum speed. In the calibration routine, once the user
indicates the fan is at speed, the maximum count value is stored and used later to
calculate %RPM.
If RPM were used, the math would have exceeded our math limits: 8000 x 100 = 80,000.
, the new-line character, is used to place text on the next line.
Calibrate
is a StampPlot instruction to request data from the user through a message box
!REQD 30,0,Maximum RPM=7850.\nEnter1 if RPM OK.\nEnter 0 if not OK.
Per_RPM = Opto_Count * 100 / Max_Count
. A simple transfer function is calculated by multiplying by the maximum
DEBUG "!REQD 0,30,Maximum RPM=", DEC RPM,
subroutine, input from the user verifies that the fan is at the correct
"\nEnter 1 if Reading OK.",
"\nEnter 0 if not OK.",CR
DEBUGIN
instruction is then used to accept the returning