ST62GP-DBE STMicroelectronics, ST62GP-DBE Datasheet - Page 23

• Manufacturer Part Number: ST62GP-DBE
• Description: DEDICATED BOARD FOR ST EMULATORS
• Manufacturer: STMicroelectronics

Specifications of ST62GP-DBE

• Accessory Type: Emulator Adaptor
• For Use With/related Products: ST62GP-EMU2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST62GP-EMU2 Emulator User Manual
4
4.1
4.2
4.3
TUTORIAL
Introduction
The goal of this tutorial is make you familiar with the emulator environment using
an example program installed in the following directory:
The example uses the standard timer of the ST6265 to toggle an I/O pin (PB0).
You can easily modify this example to work with other devices, because the
hardware resources it uses can be found on all ST6 devices supported by the
ST62GP-EMU2. To find out how to modify the program, refer to
with ST62 devices other than the ST6265
The example program is located in the following directory:
The file is called tutorial.asm.
Required tools
The following tools are required to do this tutorial:
•
•
•
Getting prepared
Before you start the tutorial, make sure your system has been correctly set-up. To
do so:
1
2
D:\Program Files\Stm\ST6toolchain\soft
D:\Program Files\Stm\ST6toolchain\soft\6x-emu2\tutorial
ST62GP-EMU2.
Oscilloscope.
5 V power supply.
Install the ST62GP-EMU2 emulator as described in
page 11.
-
-
Install the software (i.e. the WGDB6 debugger) as described in
Software
The tutorial example is based on a ST6265 device.
On the 28-pin DB449 probe board, there should be a jumper in W2 (jumper
W1 is irrelevant in this case).
on page 19.
on page 37.
installing the hardware
Using the tutorial
Installing the
4 - Tutorial
23/57
on