AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 10

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
* Must be connected if there is no external oscillator in system.
AE-ISP-U1 connection for the Atmel ATTINY10 devices in TPI Mode
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
ISP characteristics:
1. Programmer's output capability:
2. The cable length should be less then one foot.
connector, BH-10
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
Adapter Output
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
ATmegaXXXX (except ATmega103, ATmega128, AT90CAN128,
Target Device AT90/AT89S (except AT90CAN128), ATtinyXX,
ATMega1281, ATMega2561, ATMega64)
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the target
power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or external
XTAL1*
RESET
MISO
MOSI
GND
SCK
Vcc
-
-
-
Page 10 of 56
8/19/2010