EVB-USB2512Q36-BAS SMSC, EVB-USB2512Q36-BAS Datasheet - Page 31
![BOARD EVAL FOR USB2512/USB2512I](/photos/9/10/91014/evb-usb2512q36-bas_sml.jpg)
EVB-USB2512Q36-BAS
Manufacturer Part Number
EVB-USB2512Q36-BAS
Description
BOARD EVAL FOR USB2512/USB2512I
Manufacturer
SMSC
Specifications of EVB-USB2512Q36-BAS
Main Purpose
Interface, USB 2.0 Hub
Embedded
No
Utilized Ic / Part
USB2512, USB2512I
Primary Attributes
Dual Port Hub, High Speed (480Mbps), I2C/SMBus
Secondary Attributes
Overcurrent Protection, Port Power Switching, ESD Protection
Interface Type
USB
Operating Supply Voltage
5 V
Product
Interface Modules
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
USB2512
Other names
638-1041
EVB-USB2512Q36-BAS (USB2512/USB2512I)
EVB-USB2512Q36-BAS (USB2512/USB2512I)
USB 2.0 Hi-Speed Hub Controller
Datasheet
Chapter 7 Battery Charging Support
SMSC USB251x
7.1
7.2
7.2.1
The battery charging feature is only available in USB251xB (which represents USB2512B/3B/4B and
USB2512Bi/3Bi/4Bi hub family products). Any one or combination of downstream ports on the
USB251xB hub can be configured to support battery charging.
The SMSC hub provides support for battery charging devices on a per port basis in compliance with
the USB Battery Charging specification, version 1.1. The hub can be configured to individually enable
each downstream port for battery charging support either via pin strapping as illustrated in
or by setting the corresponding configuration bits via EEPROM or SMBus.
A downstream port enabled for battery charging turns on port power as soon as the configuration
process has completed. The hub does not need to be enumerated nor does VBUS_DET need to be
asserted for the port power to be enabled. These conditions allow battery charging in S3, S4 and S5
system power states as well as in the fully operational state. The USB Battery Charging specification
does not interfere with standard USB operation, which allows a device to perform battery charging at
any time.
A port that supports battery charging must be able to support 1.5 amps of current on VBUS. Standard
USB port power controllers typically only allow for 0.8 amps of current before detecting an over-current
condition. Therefore, the 5 volt power supply, port power controller or over-current protection devices
must be chosen to handle the larger current demand compared to standard USB hub designs.
Special Behavior of PRTPWR Pins
The SMSC hub enables VBUS by asserting the port power (PRTPWR) pin as soon as the hardware
configuration process has completed. If the port detects an over-current condition, PRTPWR will be
turned off to protect the circuitry from overloading. If an over-current condition is detected when the
hub is not enumerated, PRTPWR can only be turned on from the host or if RESET_N is toggled. These
General Description
USB Battery Charging
USB251xB/xBi
Note: R
STRAP
Figure 7.1 Battery Charging via External Power Supply
enables battery charging.
3.3 V
DATASHEET
PRTPWR[x]
R
OCS_N[x]
STRAP
31
5 V
IN
EN
FLAG
USB Port Power
Controller
Revision 1.1 (04-26-10)
VBUS
Figure 7.1