MAX7456EVKIT+ Maxim Integrated Products, MAX7456EVKIT+ Datasheet - Page 36

• Manufacturer Part Number: MAX7456EVKIT+
• Description: KIT EVAL FOR MAX7456
• Manufacturer: Maxim Integrated Products

Specifications of MAX7456EVKIT+

• Main Purpose: Video, On-Screen Display (OSD)
• Embedded: Yes, MCU, 16-Bit
• Utilized Ic / Part: MAX7456
• Primary Attributes: NTSC/PAL single-channel monochrome on-screen display(OSD) with integrated video driver
• Secondary Attributes: GUI, SPI Interfaces
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Single-Channel Monochrome On-Screen
Display with Integrated EEPROM
Write address = 6CH, read address = ECH.
Read/write access: This register contains 4 factory-pre-
set bits [3:0] that must not be changed. Therefore,
Read address = AxH.
Read/write access: read only.
xxxx = Factory preset—can be any one of the 16 possible values. This value is permanently stored in the MAX7456 and will always
be restored to the factory preset value following power-on reset or hardware reset.
NA = Not applicable.
X = Don’t care.
36
BIT
BIT
7–5
0–3
______________________________________________________________________________________
7
6
5
4
3
2
1
0
4
OSD Black Level Register (OSDBL)
DEFAULT
DEFAULT
xxxx
000
NA
NA
NA
NA
NA
NA
NA
NA
1
Status Register (STAT)
Don’t Care
Reset M od e
0 = C l ear w hen p ow er - up r eset m od e i s com p l ete. O ccur s 50m s ( typ ) fol l ow i ng stab l e V
1 = S et w hen i n p ow er - up r eset m od e
Character Memory Status
0 = Available to be written to or read from
1 = Unavailable to be written to or read from
VSYNC Output Level
0 = Active during vertical sync time
1 = Inactive otherwise
HSYNC Output Level
0 = Active during horizontal sync time
1 = Inactive otherwise
Loss-of-Sync (LOS)
0 = Sync Active. Asserted after 32 consecutive input video lines.
1 = No Sync. Asserted after 32 consecutive missing input video lines.
0 = NTSC signal is not detected at VIN
1 = NTSC signal is detected at VIN
0 = PAL signal is not detected at VIN
1 = PAL signal is detected at VIN
Don’t Care
OSD Image Black Level Control
This bit enables the alignment of the OSD image black level with the input image black level at
VOUT. Always enable this bit following power-on reset to ensure the correct OSD image brightness.
0 = Enable automatic OSD black level control
1 = Disable automatic OSD black level control
These bits are factory preset. To ensure proper operation of the MAX7456, do not change the
values of these bits.
when changing bit 4, first read this register, modify bit
4, and then write back the updated byte.
FUNCTION
FUNCTION
D D
( Fi g ur e 22)