EVAL-AD7785EBZ Analog Devices Inc, EVAL-AD7785EBZ Datasheet - Page 28

• Manufacturer Part Number: EVAL-AD7785EBZ
• Description: BOARD EVALUATION FOR AD7785
• Manufacturer: Analog Devices Inc

Specifications of EVAL-AD7785EBZ

• Number Of Adc's: 1
• Number Of Bits: 20
• Sampling Rate (per Second): 470
• Data Interface: Serial
• Inputs Per Adc: 3 Differential
• Input Range: ±VREF
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 105°C
• Utilized Ic / Part: AD7785
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD7785
The ground planes of the AD7785 should be allowed to run
under the device to prevent noise coupling. The power supply
lines to the AD7785 should use as wide a trace as possible to
provide low impedance paths and reduce the effects of glitches
on the power supply line. Fast switching signals such as clocks
should be shielded with digital ground to avoid radiating noise
to other sections of the board, and clock signals should never be
run near the analog inputs.
Avoid crossover of digital and analog signals. Traces on oppo-
site sides of the board should run at right angles to each other.
This reduces the effects of feedthrough through the board.
A microstrip technique is by far the best, but it is not always
possible with a double-sided board. In this technique, the
component side of the board is dedicated to ground planes, and
signals are placed on the solder side.
Rev. 0 | Page 28 of 32
Good decoupling is important when using high resolution
ADCs. AV
parallel with 0.1 μF capacitors to GND. DV
decoupled with 10 μF tantalum in parallel with 0.1 μF
capacitors to the system’s DGND plane, with the system’s
AGND to DGND connection being close to the AD7785.
To achieve the best from these decoupling components, they
should be placed as close as possible to the device, ideally right
up against the device. All logic chips should be decoupled with
0.1 μF ceramic capacitors to DGND.
DD
should be decoupled with 10 μF tantalum in
DD
should be