LM3445-EDSNEV/NOPB National Semiconductor, LM3445-EDSNEV/NOPB Datasheet - Page 2

• Manufacturer Part Number: LM3445-EDSNEV/NOPB
• Description: PROGRAMMERS, DEVELOPMENT SYSTEMS
• Manufacturer: National Semiconductor
• Series: PowerWise®r

Specifications of LM3445-EDSNEV/NOPB

• Current - Output / Channel: 205 ~ 340 mA
• Outputs And Type: 1, Non-Isolated
• Features: Dimmable
• Voltage - Input: 85 ~ 135 VAC
• Utilized Ic / Part: LM3445
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -

www.national.com
Pin #
Pin-Out
10
1
2
3
4
5
6
7
8
9
FLTR1
FLTR2
Name
ASNS
COFF
GATE
BLDR
GND
ISNS
DIM
V
CC
Description
PWM output of the triac dim decoder circuit. Outputs a 0 to 4V PWM signal with a duty cycle proportional to
the triac dimmer on-time.
First filter input. The 120Hz PWM signal from ASNS is filtered to a DC signal and compared to a 1 to 3V, 5.85
kHz ramp to generate a higher frequency PWM signal with a duty cycle proportional to the triac dimmer firing
angle. Pull above 4.9V (typical) to tri-state DIM.
Input/output dual function dim pin. This pin can be driven with an external PWM signal to dim the LEDs. It may
also be used as an output signal and connected to the DIM pin of other LM3445 or LED drivers to dim multiple
LED circuits simultaneously.
OFF time setting pin. A user set current and capacitor connected from the output to this pin sets the constant
OFF time of the switching controller.
Second filter input. A capacitor tied to this pin filters the PWM dimming signal to supply a DC voltage to control
the LED current. Could also be used as an analog dimming input.
Circuit ground connection.
LED current sense pin. Connect a resistor from main switching MOSFET source, ISNS to GND to set the
maximum LED current.
Power MOSFET driver pin. This output provides the gate drive for the power switching MOSFET of the buck
controller.
Input voltage pin. This pin provides the power for the internal control circuitry and gate driver.
Bleeder pin. Provides the input signal to the angle detect circuitry as well as a current path through a switched
230Ω resistor to ensure proper firing of the triac dimmer.
Pin Description 10 Pin MSOP
10-Pin MSOP
2
30124603