STEVAL-MKI017V1 STMicroelectronics, STEVAL-MKI017V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI017V1
• Description: BOARD ADAPTER LIS344AL DIL24
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI017V1

• Design Resources: STEVAL-MKI017V1 Gerber Files STEVAL-MKI017V1 Schematic STEVAL-MKI017V1 Bill of Materials
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±3.5g
• Interface: Analog
• Sensitivity: 0.100 x Vdd = V/g
• Voltage - Supply: 2.7 V ~ 3.3 V
• Embedded: No
• Utilized Ic / Part: LIS344AL
• Sensing Axis: Triple Axis
• Output Type: Analog
• Tool / Board Applications: Sensing - Navigation, Accelerometer, Magnetic Field
• Mcu Supported Families: LIS344AL
• Supported Devices: LIS344AL
• Rohs Compliant: Yes
• Development Tool Type: Hardware - Daughter Card
• For Use With: 497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8201

System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701