STEVAL-MKI073V1 STMicroelectronics, STEVAL-MKI073V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI073V1
• Description: BOARD DEMO MEMS LY3200ALH
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI073V1

• Sensor Type: Gyroscope, 1 Axis
• Sensing Range: ±2000°/sec
• Interface: Analog and Digital
• Sensitivity: 0.67mV/°/s
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LY3200ALH
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR5xxxAL, LPY5xxxAL, LY5xxxAL
• Other names: 497-10680

System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701