STEVAL-MKI104V1 STMicroelectronics, STEVAL-MKI104V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI104V1
• Description: BOARD DEMO MEMS LPY403AL
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI104V1

• Sensor Type: Gyroscope, 2 Axis
• Sensing Range: ±30°/sec
• Interface: Analog and Digital
• Sensitivity: 33.3mV/°/s
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LPY403AL
• Sensing Axis: Triple Axis
• Output Type: Digital
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LIS302DL
• Other names: 497-10681

Application hints
5
10/14
Application hints
Figure 3.
Power supply decoupling capacitors (100 nF ceramic or polyester + 10 µF aluminum) should
be placed as near as possible to the device (common design practice).
The LPY403AL allows band limiting of the output rate response through the use of an
external low-pass filter (recommended) in addition to the embedded low-pass filter (f
Hz).
The 4xOUTX and 4xOUTZ are, respectively, OUTX and OUTZ amplified output lines,
internally buffered to ensure low output impedance.
If external low-pass filtering is not applied, it is mandatory to short-circuit pin 1 to pin 5 and
pin 16 to pin 20, respectively, when amplified outputs are used.
When only a non-amplified output is used (OUTX/OUTZ), it is recommended to set pin 5
and 16 to a fixed reference voltage (Vref).
The LPY403AL IC includes a PLL (phase-locked loop) circuit to synchronize driving and
sensing interfaces. Capacitors and resistors must be added at the FILTVDD and VCONT
pins (as shown in
LPY403AL electrical connections and external component values
Figure
3) to implement a low-pass filter.
Doc ID 16577 Rev 1
LPY403AL
t
= 140