STEVAL-MKI109V1 STMicroelectronics, STEVAL-MKI109V1 Datasheet - Page 23

• Manufacturer Part Number: STEVAL-MKI109V1
• Description: MOTEHRBOARD MEMS ADAPTER STM32
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI109V1

• Main Purpose: Motherboard; Accelerometer, Gyroscope
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: STM32 and MEMS Demo Boards
• Primary Attributes: DIL24 Socket for ST MEMS Adapter Boards
• Secondary Attributes: 3 V on-board linear voltage regulator
• Sensing Axis: Triple Axis
• Operating Voltage: 5 V
• Operating Current: 0.68 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LIS344ALH
• Other names: 497-10682

STM32F102x8, STM32F102xB
5
5.1
5.1.1
5.1.2
5.1.3
5.1.4
5.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3).
Typical values
Unless otherwise specified, typical data are based on T
2 V  V
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Pin input voltage
The input voltage measurement on a pin of the device is described in
DD
 3.6 V voltage range). They are given only as design guidelines and are not
Doc ID 15056 Rev 3
A
A
= 25 °C and T
SS
= 25 °C, V
.
.
Electrical characteristics
DD
A
Figure
= 3.3 V (for the
= T
Figure
A
max (given by
7.
6.
23/69