STM8/128-EV/TS STMicroelectronics, STM8/128-EV/TS Datasheet - Page 11

• Manufacturer Part Number: STM8/128-EV/TS
• Description: EVAL KIT TOUCH SENSING STM8S
• Manufacturer: STMicroelectronics
• Series: STM8Sr

Specifications of STM8/128-EV/TS

• Sensor Type: Touch, Capacitive
• Sensing Range: 5 Buttons/Keys, Slider
• Interface: I²C
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STM8S2xx
• Processor To Be Evaluated: STM8S
• Data Bus Width: 8 bit
• Interface Type: I2C
• Silicon Manufacturer: ST Micro
• Core Architecture: STM8
• Core Sub-architecture: STM8
• Silicon Core Number: STM8
• Silicon Family Name: STM8S2xx
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Voltage - Supply: -
• Sensitivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: STM8Sxxx-TS1
• Other names: 497-10031

UM0671
3.1.3
3.1.4
Note:
Daughterboard power supply
By default, the daughterboard is powered through the motherboard. The 3.3 V regulator on
the daughterboard supplies the daughterboard MCU.
The MCU current consumption (I
SWIM connections
The STM8 debug system interface allows a debugging or programming tool to be connected
to the MCU through a single-wire bidirectional communication based on open-drain line.
This single-wire interface module (SWIM) module allows non-intrusive read/write accesses
to be performed on-the-fly to the RAM and peripheral registers, for debug purposes.
The SWIM module can also perform a MCU device software reset and can also be used by
as a standard I/O port with some restrictions.
Jumper W1 is used to configure SWIM settings as described in
Table 3.
For more information, please refer to user manual UM0470: STM8 SWIM communication
protocol and debug module.
Figure 6.
Table 4.
The SWIM connector of the STM8/128-EVAL board cannot be used.
Pin number
Configuration
1
1
1
3
2
2
3
3
W1 jumper description
SWIM connector (top view)
SWIM connector pin description
VDD
GND
Uses STM8S TS daughterboard SWIM connector (default setting)
Connect PD1of STM8S TS daughterboard device to resource of STM8S/128-
EVAL board.
Description
Doc ID 15330 Rev 4
DD
) can be measured by removing jumper W2.
1
2
Pin number
3
Description
4
2
4
PD1
PA0 (RESET)
Evaluation kit board settings
Table
3.
Description
11/23