101-1243 Rabbit Semiconductor, 101-1243 Datasheet - Page 4

• Manufacturer Part Number: 101-1243
• Description: SECURE EMBEDDED WEB APPLICATIONS
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 4000r
• Type: MPU Moduler

Specifications of 101-1243

• Contents: Prototype Board, Power Supply and Accessories
• Interface Type: Ethernet
• Operating Voltage: 3.3 V
• Board Size: 47 mm x 72 mm x 21 mm
• Product: Modules
• For Use With/related Products: RCM4300
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1136

Computer Setup
Follow these instructions to set up your computer. Check with your administrator if you are
unable to change the settings as described here since you may need administrator privileges. The
instructions are specifically for Windows XP, but the interface is similar for other versions of
Windows.
1. Go to the control panel (Start > Settings > Control Panel), and then double-click the Network
2. Select the Local Area Connection and click the “Properties” button on the “General” tab. Click “Internet
3. Assign the following IP address settings to your computer (this will disable “obtain an IP address auto-
4. Click <OK> or <Close> to exit the various dialog boxes.
Use the Cat. 5 Ethernet crossover cable to connect the RCM4300 to your computer’s RJ-45 Ethernet jack.
Connections icon.
Protocol (TCP/IP)” and click the “Properties” button on the “General” tab.
In earlier versions of Windows, you would select the network interface card used for the Ethernet inter-
face you intend to use (e.g., TCP/IP Xircom Credit Card Network Adapter) and click on the
“Properties” button. Now “Configure” your interface card for an “Auto-Negotiation” connection on the
“Advanced” tab. Now select the IP Address tab, and check Specify an IP Address, or select TCP/IP
and click on “Properties” to assign an IP address to your computer (this will disable “obtain an IP
address automatically”)
matically”):
TIP: If you are using a computer that is already on a network, disconnect the computer from that
NOTE: Your network interface card will likely have a different name.
IP Address : 10.10.6.101
Netmask : 255.255.255.0
Default gateway : 10.10.6.1
network to run these sample programs. Write down the existing settings before changing them
to facilitate restoring them when you are finished with the sample programs and reconnect your
computer to the network.
IP 10.10.6.101
Netmask
255.255.255.0
Direct Connection PC to RCM4300 Module
User’s PC
Ethernet
crossover
cable
022-0127 Rev. A
RCM4300
System
4