32212 Parallax Inc, 32212 Datasheet - Page 6

• Manufacturer Part Number: 32212
• Description: BOARD PROPELLER PROTO
• Manufacturer: Parallax Inc
• Series: Propeller™r
• Type: MCUr

Specifications of 32212

• Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: P8X32A
• For Use With: 130-32212 - KIT ACC PROPELLER PROTO BOARD122-32000 - MANUAL PROPELLER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 32212PAR

Add the 100 Ω and 470 Ω Resistors
Add the Norcomp Connector (right)
Add the Servo Circuit (below)
IMPORTANT: Servo Power Supply (Vin)
Use only the Vin jumper setting for powering servos when power is supplied from a 6V battery pack.
Damage could occur to your servos if you use an unregulated power supply.
Note:
on the Propeller Proto Board. If only PS/2 connectors are installed, only the 100 Ω resistors need to be
installed. If only a VGA connector is installed, only the 470 Ω resistors need to be installed.
Copyright © Parallax Inc.
If only video or PS/2 peripherals are needed for an application, standard connectors may be used
Remove the resistors from their packaging.
Take a 100 Ω resistor (brown-black-brown-gold) and
bend one lead near the resistor so that it points in
the same direction as the other lead.
Place it in the two holes marked 100 right above the
Rev A label and solder it in place so the resistor is in
vertical orientation.
Repeat this process for 3 more 100 Ω resistors
moving upwards (you will have 1 spare 100 Ω
resistor left).
Repeat this process using (3) 470 Ω (yellow-violet-brown-gold); placing each resistor in the 3
sets of holes marked 470.
Place the Norcomp integrated SVGA and PS/2 mouse and
keyboard connector in the board.
Solder the signal lines in the four corners (signal lines are the
smaller pins).
Once the connector is securely in place and level, solder the
remaining signal pins, then solder the mechanical pins (the
mechanical pins are the larger pins around the perimeter of the
connector).
The VGA/mouse/keyboard circuit is now installed.
Solder a 3 pin header into the 3 holes to the right of the 3.3V
regulator.
Solder the 4 remaining 3 pin headers to the right of the electrolytic
capacitor.
Install the shorting block on the first header to choose the servo
supply.
Propeller Proto Board (#32212), USB (32812) Accessory Pack (122-32212) v1.2 5/23/2008 Page 6 of 6