CY8CKIT-014 Cypress Semiconductor Corp, CY8CKIT-014 Datasheet - Page 11

• Manufacturer Part Number: CY8CKIT-014
• Description: KIT DEV PSOC5 FIRST TOUCH
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoC® 5, FirstTouch™r
• Type: MCUr

Specifications of CY8CKIT-014

• Contents: Board, Battery, Cable, CD, Documentation, Wire
• Processor To Be Evaluated: CY8C5588AXI
• Processor Series: CY8C55
• Interface Type: USB
• Operating Supply Voltage: 9 V
• Silicon Manufacturer: Cypress
• Core Architecture: PSoC
• Silicon Family Name: PSoC
• Kit Contents: Board, CD, Cable
• Features: Programmable System-on-chip Design Methodology And Architecture
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: CY8C55
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 428-3039

CY8CKIT-014 PSoC 5 FirstTouch Starter Kit Guide, Spec. # 001-57708 Rev. *A
3. As specified, this installation process first determines if you have all prerequisite software. Follow
4. Following the software installation, verify you have all hardware and drivers setup for the PSoC 5
5. Now, verify your installation and setup by opening PSoC Programmer with the kit board attached
Figure 3-4. Opening PSoC Programmer
6. Close PSoC Programmer
7. Open PSoC Creator and continue on to the next section to experiment with the included example
the on-screen dialogs to complete all required installations. After following these steps, you must
have the following software installed:
a. PSoC Creator 1.0
b. PSoC Programmer 3.12.3 or later
c. GNU GCC Compiler (for PSoC 5 development)
d. PSoC 5 FirstTouch Starter Kit example projects and documentation
FirstTouch Starter Kit by connecting the kit board to your PC via its USB interface. As this is the
first time you have connected this board to this PC, initial driver installations occur. Should any
on-screen dialogs appear, follow them to complete the installation process.
Note After the installation is complete, the kit contents are found at the following location:
C:\Program Files\Cypress\PSoC 5 FirstTouch Starter Kit\
over USB. To open PSoC Programmer, click Start
Programmer 3.12.3
should see the PSoC 5 FirstTouch starter kit. If you do, you have successfully installed all
required software and drivers to begin your PSoC 5 evaluation. Congratulations!
projects.
→
PSoC Programmer (see
Figure
→
Programs
3-4). In the port selection frame, you
→
Cypress
→
PSoC
Installation
11