PK-HCS08GB60 SofTec Microsystems SRL, PK-HCS08GB60 Datasheet - Page 34

• Manufacturer Part Number: PK-HCS08GB60
• Description: KIT STARTER USB FOR MC9S08GB60
• Manufacturer: SofTec Microsystems SRL
• Type: MCUr

Specifications of PK-HCS08GB60

• Contents: Board, Cable, Software, Datasheets and User Manual
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Kit Contents: Emulator/Programmer
• Mc9s08gb60 Evaluation Board: Silicon Family Name
• Silicon Core Number: MC9S08GB60
• Core Sub-architecture: HCS08
• Silicon Family Name: S08GB
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Freescale MC9S08GB60 (USB)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Contains lead / RoHS non-compliant
• Other names: 520-1014

5. Troubleshooting
Common Problems and Solutions
This section reports some common problems that may arise during general use.
Communication Can’t Be Established with PK-HCS08GB60
1. Make sure the PK-HCS08GB60 starter kit is connected to the PC and powered on. PK-
2. If you connected the PK-HCS08GB60 board to the PC before installing the CodeWarrior
HCS08GB60 is powered by the USB connection.
user interface and the SofTec Microsystems Additional Components, the PK-
HCS08GB60 USB driver may not have been correctly installed on your system.
Unplugging and replugging the USB cable is of no use, since Windows has marked the
device as “disabled”. As a consequence, CodeWarrior cannot communicate with the
PK-HCS08GB60 board.
To restore the USB driver (provided both CodeWarrior and SofTec Microsystems
Additional components have been installed), perform the following steps under
Windows XP:
§
§
§
§
§
§
§
Plug the PK-HCS08GB60 board to the PC.
Open the Control Panel (Start > Settings > Control Panel).
Open the “System” options.
Select the “Hardware” tab.
Click the “Device Manager” button.
The “PK-HCS08 Series Starter Kit” device will be shown with an exclamation
mark next to it. Double click on this device.
In the “General” tab, click the “Reinstall Driver” button. Follow the on-screen
instructions.
PK-HCS08GB60 User's Manual
Page 33
5