C8051F996DK Silicon Laboratories Inc, C8051F996DK Datasheet - Page 2

• Manufacturer Part Number: C8051F996DK
• Description: KIT DEV FOR C8051F996
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F996DK

• Contents: Board, Batteries, Cables, CDs, Debug Adapter, Documentation, Power Adapter
• Processor To Be Evaluated: C8051F996
• Processor Series: C8051F98x
• Interface Type: USB
• Operating Supply Voltage: 3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F996
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1963

C8051F996-DK
3. Hardware Setup
Refer to Figure 2 for a diagram of the hardware configuration.
1. Connect the USB Debug Adapter to the DEBUG connector on the target board with the 10-pin ribbon cable.
2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
3. Verify that a shorting block is installed on J17 and that SW5 is in the ON position.
4. Connect the other end of the USB cable to a USB Port on the PC.
5. Connect the ac/dc power adapter to power jack P2 on the target board (Optional).
Notes:


2
Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can
damage the device and/or the USB Debug Adapter.
TB1
R15
J16
J15
J18
J6
TOUCH SENSE SWITCH
J3
J5
P1.0
VDD
SILICON LABS
Target Board
www.silabs.com
J7
U1
TOUCH SENSE SWITCH
F996
Figure 2. Hardware Setup using a USB Debug Adapter
P1.1
`
OFF
ON
J2
J13
J14
SW5
J8
P1.3
P1.5
IMEASURE
AAA_BAT
RESET
COIN_CELL
WALL_PWR
J17
H2
+3VD PWR
USB POWER
P0.2
PWR
J11
2103
J1
U3
PWR
CP
P0.3
J12
P2
P3
SW4
J9
Rev. 0.1
USB Debug
Adapter
Adapter
AC/DC
Cable
USB
PC