C8051F336DK Silicon Laboratories Inc, C8051F336DK Datasheet - Page 4

• Manufacturer Part Number: C8051F336DK
• Description: DEV KIT FOR C8051F336
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F336DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F33x
• Interface Type: USB, UART
• Operating Supply Voltage: 7 V to 15 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F336
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1430

C8051F336DK
4.4. Keil uVision2 and uVision3 Silicon Laboratories Drivers
As an alternative to the Silicon Laboratories IDE, the uVision debug driver allows the Keil uVision IDE to
communicate with Silicon Laboratories on-chip debug logic. In-system Flash memory programming integrated into
the driver allows for rapidly updating target code. The uVision IDE can be used to start and stop program
execution, set breakpoints, check variables, inspect and modify memory contents, and single-step through
programs running on the actual target hardware.
For more information, please refer to the uVision driver documentation. The documentation and software are
available from the Downloads webpage (www.silabs.com/mcudownloads).
5. Hardware Setup using a USB Debug Adapter
The target board is connected to a PC running the Silicon Laboratories IDE via the USB Debug Adapter as shown
in Figure 2.
Notes:
4
J11
1. Connect the USB Debug Adapter to the DEBUG connector on the target board with the 10-pin ribbon cable.
2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
3. Connect the other end of the USB cable to a USB Port on the PC.
4. Connect the ac/dc power adapter to power jack P1 on the target board.
• Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
• Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can
damage the device and/or the USB Debug Adapter.
SW3
+3VD
GND
R14
J7
TB1
J1
J8
J6
SILICON LABS
D7
J5
www.silabs.com
Target Board
P1.3
P0.7
J9
Figure 2. Hardware Setup using a USB Debug Adapter
F338
U1
J3
RESET
J10
D4
J2
USB
2102
U3
CP
P1
P2
D6
PWR
J4
USB Debug
Adapter
Rev. 0.2
Adapter
AC/DC
Cable
USB
PC