701891 Spectrum Digital Inc, 701891 Datasheet - Page 4

• Manufacturer Part Number: 701891
• Description: KIT STARTER DSP FOR C6416T
• Manufacturer: Spectrum Digital Inc
• Type: DSPr

Specifications of 701891

• Contents: Board, Cable, CD, Power Supply
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: TMS320C6416T
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Debug Hints and Trouble Shooting
1.
2.
3.
4.
5.
12502 Exchange Dr., Ste 440, Stafford, TX. 77477
If installing on Windows XP and your PC is connected
to the internet through a firewall the USB install may
take up to 15 minutes if you let it complete normally.
The work-around for this issue is to simply disconnect
your network cable during the USB hardware install.
Make sure all of the Configuration Switches (SW3)
are set in the off position. This configures the DSK for
the factory default settings of little endian processor
mode booting out of the on-board Flash memory.
Some of the Help Files are links to Adobe Acrobat
PDF files. If you intend to access these files you must
have Adobe Acrobat installed on your system.
If you want to verify a successful USB driver install,
open your device manager by right clicking on the My
Computer icon on your desktop and selecting
Properties --> HW --> Device Manager. You should
see a new class “SD USB Based Debug Tools” and
one Spectrum Digital TMS320C6416 DSK installed.
The BUSY LED above the USB connector comes on
when power is applied to the DSK. Do not launch
Code Composer until the LED is off.
The best place to look for DSK
troubleshooting and software
updates is:
http://support.spectrumdigital.com
T:281.494.4505, F:281.494.5310
508036-4001A
Error Messages
Many of the error messages below refer to USB
enumeration issues. The following window will appear
when launching CCS or the Diagnostic Utility indicating
the enumeration status.
1.
2.
3.
4.
5.
Message:
Failed: Requires Win98, Win2K or Win XP.
Problem: Your operating system does not support
USB.
Message:
Failed: USB device is NOT enumerated or plugged in.
Problem: Windows cannot find the DSK. Check
power and USB Cable.
Message:
Failed: Load USB Application.
Problem: Loader could not download the DSK
emulation application. The on-board emulation
controller could be in a bad state. Cycle power on the
DSK.
Message:
Failed: USB Channel in use by another app.
Problem: Another application is using the DSK USB
communication channel. Only one application is
allowed to communicate to the DSK over the USB
channel at the same time. Check for active
applications using the Windows Task Manager if open
application is not obvious.
Message:
Status: This is a status message which indicates that
Code Composer Studio is waiting for communication
with the on-board JTAG emulator to be established.
This should take less than 10 seconds. Do not hit the
close button unless it is clear that something is wrong
(the progress bar runs forever).
Waiting for USB Enumeration.
www.spectrumdigital.com
Page 4 of 4