DC-ME-NET Digi International, DC-ME-NET Datasheet - Page 65

• Manufacturer Part Number: DC-ME-NET
• Description: KIT JUMP START ME FOR NET+OS 7.X
• Manufacturer: Digi International
• Series: JumpStartr
• Type: MCU Moduler

Specifications of DC-ME-NET

• Contents: Module, Development Board, Digi JTAG Link, Cable, Power Supply and Software
• Data Rate: 11 Mbps
• Memory Type: Flash, SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 850 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 85 C
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Digi Connect ME Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1086

65
Revision E
Revision D
Revision C
Revision B
Revision 90000631_G>90000897_A
Revision G
      
Changed schematics in appendix A to reflect correct measurements.
Added a new section labeled “Thermal Specifications” to the book. This section outlines
the temperature ranges at which the devices specified can still function properly.
Updates to schematics in Chapter 2.
Added/revised Module Pin-out table in Chapter 3.
Updated GPIO tables throughout book.
Fixed page numbers to make them correspond in PDF form.
Added components to Development Board schematics. (#19 and 20)
Added Connect ME 9210 related information.
Updated schematics in development board chapter to reflect 9210 changes.
Updated the Connectors: power and device interface section to say that pins 1 and 2 on the
connector are available if using Connect ME, not available if using Connect Wi-ME.
Updated the Embedded Module Connector table in Chapter 2 similarly.
Added tolerance information for dimension drawings
Updated Hard Reset section to clarify forcing the unit into hard reset