100-3040 Bluetechnix, 100-3040 Datasheet - Page 22

• Manufacturer Part Number: 100-3040
• Description: KIT BLACKFIN STARTER CM-BF538
• Manufacturer: Bluetechnix
• Type: DSPr

Specifications of 100-3040

• Contents: Board, Module, Power Supply
• For Use With/related Products: ADSP-BF548 Blackfin® Processor
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5 Switches, Jumper and LED Description
5.1 S1 – Reset switch
Performs system reset.
5.2 S2 – Ethernet Control Signals / SDCARD CS
5.3 S3 – UART Switch
Move S3 to position 1 to route the Core Modules RX0 and TX0 signals to USB
Move S3 to position 0 to route the Core Modules RX1 and TX1 signals to USB
5.4 S4 – Boot Configuration
S4.1 to S4.4 Control the boot mode and are described in chapter 6 Boot Mode Description.
5.5 JP1 – Ethernet Speed Selection
Set jumper JP1 to select Ethernet Speed 10MBit/s and unset JP1 for 100Mbit/s.
5.6 JP2 -– Power Supply Jumper
This jumper can be removed in order to insert an AMPERE METER for current measurement:
5.7 JP3 – RTC Power Jumper
This jumper is used to connect the VddRTC pin of the Core Module to 3.3V. You can also use this jumper
to connect a battery to the internal RTC of the Blackfin.
Blackfin DEV-BF548-Lite. DEV-BF548DA-lite Hardware User Manual
Dipswitch
S2.1
S2.2
S2.3
S2.4
Dipswitch
S4.1
S4.2
S4.3
S4.4
S4.5
S4.6
S4.7
S4.8
Function
Connect SDCARD CS to PC5
Connect nAMS1 from Core Module to Ethernet chip
Connect PE6 from Core Module to Ethernet chip IRQ
Connect PME of Ethernet chip to test point PME1
Function
Bootmode 0
Bootmode 1
Bootmode 2
Bootmode 3
Power Supply for CAN0 Driver IC
Power Supply for CAN1 Driver IC
Connect TXD‐USB to VCC
Connect S5 to VCC
5-1 DIP switch S2
5-2 DIP switch S4
Default Settings
21