IPTR-DSPBUILDER Altera, IPTR-DSPBUILDER Datasheet - Page 5

• Manufacturer Part Number: IPTR-DSPBUILDER
• Description: DSP BUILDER SOFTWARE
• Manufacturer: Altera
• Type: DSPr

Specifications of IPTR-DSPBUILDER

• Function: DSP Builder
• License: Renewal License
• Software Application: IP CORE, DSP BUILDER
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Altera Corporation
2.
Using Multiple Versions of DSP Builder
The DSP Builder install program searches for any previous installations
of DSP Builder before it installs a new version. If an existing installation
is found, the program prompts you to modify, repair or remove the old
version.
You cannot use multiple versions of DSP Builder in Simulink at the same
time. However, you can install multiple versions on the same computer
and switch between them as described below.
If you would like to keep multiple versions of DSP Builder on the same
computer, copy the existing <install path>\DSPBuilder directory to a
separate location. When you run the DSP Builder installation program, go
ahead and remove the older version DSP Builder as prompted. This will
remove references to the old location without removing the separate
copy. You can then re-run the install program which prompts you for the
location of the new version.
If you have multiple versions of DSP Builder installed, the MATLAB path
variable may have multiple entries for the AltLib folder. You should
remove the old path if you do not want to use the previous version. If you
would like to switch to using the older version of DSP Builder, enter these
commands at the MATLAB prompt:
1.
2.
3.
4. setup_dspbuilder r
You can switch back to the new version of DSP Builder using similar steps
to change the paths to the new location.
Specifying 3rd Party Synthesis Tool Paths for SignalCompiler
To launch the LeonardoSpectrum, Precision RTL, Synplify, or Quartus II
software, SignalCompiler retrieves the software’s path information from
your registry file.
Click the Start icon in the lower left corner of the main MATLAB
window. Point to Simulink and click Library Browser. The Altera
DSP Builder folder is available in the Simulink Library Browser
window.
rmpath <path to new version>\DSPBuilder\AltLib r
addpath <path to old version>\DSPBuilder\AltLib r
cd <path to old version>\DSPBuilder\AltLib r
Software Version 6.0 SP1
Preliminary
Obtain & Install DSP Builder
DSP Builder Release Notes
5