STEVAL-TLL004V1 STMicroelectronics, STEVAL-TLL004V1 Datasheet - Page 8

• Manufacturer Part Number: STEVAL-TLL004V1
• Description: BOARD EVAL FLASH DRIVER STCF03
• Manufacturer: STMicroelectronics

Specifications of STEVAL-TLL004V1

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8431

Starting up
5
8/10
Starting up
Perform the following steps to start the system:
1.
2.
3.
4.
5.
6.
7.
8.
Connect the daughterboard to the motherboard using headers H2 and H3
Power up the board either through the external power supply or through a battery, and
connect the corresponding jumper on J2 as explained in
Connect the motherboard to the computer using the USB cable
Run the GUI.exe from Packet_Creator_ST7.exe or Register_Controller.exe
Press the “scan ports for demonstration board” button on the GUI. If there is an error
during the connection, the message “demonstration board has not been connected to
any COM port.” will appear. In this case, press “close connection” on the GUI, press the
reset button on the motherboard and repeat this step from the beginning.
When step 5 is successfully completed, the virtual COM port number will be displayed.
Press the “I
auxiliary LED on the daughterboard will blink and the “test pass” message will be
displayed on the GUI.
At this point, the user can proceed with different flash and torch options on the GUI.
2
C communication test” button on the GUI. If the test is successful, the
Section 1.1
and
1.2
UM0682