DM163005 Microchip Technology, DM163005 Datasheet - Page 11

• Manufacturer Part Number: DM163005
• Description: KIT EVAL PIC16C432/433 LIN BUSS
• Manufacturer: Microchip Technology

Specifications of DM163005

• Module/board Type: Demonstration Board
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: PIC16C432, PIC16C433 LIN Bus
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2.3
 2004 Microchip Technology Inc.
HARDWARE DESCRIPTION
To erase an EEPROM/Flash device:
• Enable your programmer in MPLAB IDE. If you change programmers, you will
• Place the device in the programmer.
• Select Erase Program Memory or the equivalent erase command from the
2.2.2
To reprogram the erased sample device, the following will be necessary:
1. Sample programs installed on the hard drive.
2. An assembler, such as MPASM
3. A device programmer, such as PRO MATE
4. Once the sample program is in hex file format, a programmer may be used to
If the code protection bit(s) have not been programmed, the on-chip program memory
can be read out for verification purposes.
2.3.1
Much of the circuitry on each of the subsystem boards is the same. These building
blocks will be referred to later in each of the node descriptions without further detail.
2.3.1.1
The power supplies on each board are built around an automotive grade voltage
regulator. The voltage regulators are protected by a reverse polarity blocking diode and
a 45V Zener diode, filtered on both the input and output. An LED is connected to the
output for ’power-on’ indication.
2.3.1.2
The Local Interface Network transceiver is socketed to accept an industry standard LIN
or K/L-Line transceiver. The Microchip Technology MCP201 can be accommodated by
removing the jumper connecting pin 3, V
have to restart MPLAB IDE.
Programmer menu.
Note:
Note:
The PICDEM LIN package includes a 3.5-inch disk, which contains sample
programs for all the processor types supported. Instructions on how to install the
programs can be found in the “README” file also on the disk.
Sample programs may be used to program the sample device once they have
been assembled. Microchip Technology’s MPLAB Integrated Development
Environment (IDE) includes an assembler (MPASM). However, other assemblers
may be used.
program a blank device. Microchip Technology’s PRO MATE II or PICSTART
Plus programmers may be used. Both are compatible with MPLAB IDE. How-
ever, other programmers may be used.
Reprogramming the Sample Device
Circuits in Common
POWER SUPPLY
LIN BUS TRANSCEIVER
You do not have to erase an EEPROM/Flash device before
reprogramming it.
Microchip does not recommend code protecting windowed
devices.
TM
Assembler available with MPLAB IDE.
DD
, to the board V
®
II.
Getting Started
CC
power plane.
DS41185C-page 7
®