STEVAL-MKI044V1 STMicroelectronics, STEVAL-MKI044V1 Datasheet - Page 9

• Manufacturer Part Number: STEVAL-MKI044V1
• Description: BOARD EVALUATION FOR LPR530AL
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI044V1

• Sensor Type: Gyroscope, 2 Axis (Yaw Rate)
• Sensing Range: ±300°/sec
• Interface: Analog
• Sensitivity: 3.33mV/°/s
• Embedded: No
• Utilized Ic / Part: LPR530AL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-9089

UM0701
5
5.1
5.1.1
Note:
System setup
The system consists of three boards: the STM32 demonstration board, the STM32-MEMS
demonstration board and the MEMS demonstration board. The set-up of the system can be
split into three main steps.
1.
2.
3.
4.
Steps 1 to 3 vary according to the type of STM32 demonstration board and MEMS
demonstration board used. They are described in the following chapters.
Regarding step 4: all MEMS demonstration boards compatible with the DIL24 socket can be
connected to the STM32-MEMS board. The correct orientation of the board is depicted in
Figure 4
Figure 4.
System setup with STM3210B-EVAL board
Connecting the STM32-MEMS board
Table 1.
The CN4 connector of the STM32-MEMS board is connected to the JP11 jumper of the
STM3210B-EVAL board in order to distribute V
JP16 jumper of the STM32-MEMS board takes over the V
JP11 jumper of the STM3210B-EVAL board.
Set-up of the STM32 demonstration board. In some cases, minor changes may have to
be made to the board.
Set-up of the jumpers on the STM32-MEMS board.
Connection of the STM32-MEMS board to the STM32 demonstration board.
Connection of the MEMS demonstration board to the STM32-MEMS board.
by the ST logo printed on the top side of the STM32-MEMS board.
Pin of STM32-MEMS board
Connecting MEMS demonstration board to STM32-MEMS board
Connecting the STM32-MEMS board to the STM3210B-EVAL board
CN1-1
CN2-1
CN4-1
Doc ID 15703 Rev 1
CC
to the MEMS sensor. In this setup, the
Connected to pin of STM3210B-EVAL
BAT
selection functionality of the
CN12-1
CN13-1
JP11-1
System setup
9/42