863 B&K Precision, 863 Datasheet - Page 125

• Manufacturer Part Number: 863
• Description: PROGRAMMER SER EPROM +150MCNTRLR
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 863

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: Serial EEPROM and Microchip PICmicro Microcontrollers
• Other names: BK863

Options / Log file
Options / Protected mode
This setting is saved to disk by command Options / Save
options.
This options associates with using of Log window. All reports
for this window can be written into the Log file too. The Log
file name as REPORT.REP and the control program creates
this file in current directory.
Sets New caused deleting old Log file if exist and creating a
new file for reports. Sets Append adds all reports into existing
Log file. If file not exist, the new file will be created. Settings
are applied only at program start.
This setting can be saved to disk by command Options / Save
options. Default form is set to a using Log window without Log
file i.e. all reports will be displayed to a Log window only.
Protected mode is special mode of program. When program is
in Protected mode, there are disabled program operation and
commands which can modify buffer or device settings.
Protected mode is used for prevent operator from modify buffer
or device settings due to insignificance. Protected mode is
suitable for the programming of a large amount of the same
type of devices.
There are two ways how to switch program to Protected mode:
To switch program from Protected mode to normal mode use
the menu command Options / Normal mode. The ”Password
required" dialog appears. User have to enter the same
password as the password entered during switch to Protected
mode.
Other way to cancel Protected mode of program is closing of
program, because program Protected mode is active until
program is closed. The next program start will be to Normal
(standard) mode (the only exception is case of project loaded
by command line parameter name of project and the project
was saved in Protected mode).
1. by using menu command Options / Protected mode.
2. by reading project, which was previously saved in
This command displays password dialog. User have to
enter password twice to confirm the password is correct.
After
Protected mode. The entered password is then used to
switch off Protected mode.
Protected mode.
password
confirmation
125
program
switches
Software
to