866 B&K Precision, 866 Datasheet - Page 34

• Manufacturer Part Number: 866
• Description: PROGRAMMER UNIV W/ USB INTERFACE
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 866

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: EPROM, EEPROM-Flash, Serial EPROM, Microcontroller & PLD
• Other names: 866BK; Q2005647

Manipulation with the programmed
device
In-system serial programming by
866
Problems
interconnection, and their removing
Description of 866 ISP connector
If you have any problems with 866
see section Common notes please.
After selection of desired device for your work, you can insert
into the open ZIF socket (the lever is up) and close socket (the
lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket
on the programmer's cover. The programmed device is
necessary to insert into the socket also to remove from the
socket when LED BUSY light off.
Note: Programmer's protection electronics protect the target
device and the programmer itself against either short or long-
term power failures and, partly, also against a PC failure.
However, it is not possible to grant the integrity of the target
device
parameters. Target device may be not destroyed by forced
interruption of the control program (reset or switch-off PC), by
removing the physical connection to the programmer, but the
content of actually programmed cell may remains undefined.
Don't unplug the target device from the ZIF socket during work
with device (LED BUSY shine).
For general definition, recommendation and direction about
ISP see section Common notes / ISP please.
Specification of ISP connector pins depends on the device,
which you want to program. You can find it in the control SW
due
Front view at ISP connector of programmer.
related
to
incorrect,
2
1
4
3
34
to
6
5
8
7
user-selected
the
10
9
PC interconnection,
866
programming
PC