FS2003-UPG7 Equinox Technologies, FS2003-UPG7 Datasheet - Page 54

• Manufacturer Part Number: FS2003-UPG7
• Description: UPGRADE FS2003 JTAG ISP AVR MCU
• Manufacturer: Equinox Technologies
• Type: Upgrade Kitr

Specifications of FS2003-UPG7

• Mfg Application Notes: SPI and JTAG (ISP), Appl Note
• For Use With/related Products: FS2003
• Other names: 483-1009

4. Wait for the programmer to CRC check the Programming Project
LCD Display
5. Press the RED <YES> button again to execute the Programming Project
LCD Display
6. Programming Project – PASS
If the Programming Project programs the target device without any errors:
LCD Display
FS2003 ISP Programmer - User Guide V1.08 – 1
•
•
•
•
•
•
•
•
•
•
The programmer performs a full CRC validation check of the entire Programming Project
stored in the programmer ‘FLASH Memory Store’.
If the check is OK, the programmer goes to step (5).
If the check FAILS, the programmer will display ‘Internal Image is corrupted’. Please try re-
uploading your Project Collection and then repeat the Standalone Mode process from the
beginning.
The Programming Project will now start to execute.
The <BUSY> LED will illuminate to denote that the programmer is active.
This may take a few seconds or a few minutes depending on the nature of the Programming
Project.
The Programming Project will either PASS or FAIL
The <PASS> LED will FLASH
The LCD will display: ‘Operation Complete OK!’
Press <YES> key to program another device
operation is displayed
Current programming
CHECKING IMAGE
COMPLETE OK
OPERATION
PAGE n
Buttons
Buttons
To abort the
programming
sequence at any
time, press
Buttons
Press
To program
another device.
st
August 08
Status LED
Display
Status LED
Display
Status LED
Display
51