DV243003 Microchip Technology, DV243003 Datasheet - Page 13

• Manufacturer Part Number: DV243003
• Description: KIT STARTER FOR SRL MEM PRODUCTS
• Manufacturer: Microchip Technology
• Series: MPLAB®r
• Type: Serial EEPROMr

Specifications of DV243003

• Contents: Design board and Software
• Processor To Be Evaluated: PIC18F67J50
• Processor Series: PIC18F
• Interface Type: USB, I2C, SPI
• Operating Supply Voltage: 3.3 V to 5 V
• Ic Product Type: Programmer
• Supported Families: Serial EEPROM
• Ic Interface Type: USB
• Kit Contents: MPLAB Starter Kit, MPLAB IDE, Interface Tool, Guide, Cables
• Features: USB Interconnect, Windows 2000, XP, And Vista
• Development Tool Type: Hardware / Software - Starter Kit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: MPLAB®
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2.1
2.2
2.3
© 2008 Microchip Technology Inc.
CONNECT THE BOARD TO THE PC
SELECT A DEVICE, WRITE AND READ
USE THE ENDURANCE UTILITY
Chapter 2. Using the Memory Starter Kit
This chapter describes the Memory Starter Kit functionality and how to:
• Connect the board to the PC
• Select a Device, Write and Read
• Use the Endurance Utility
• Change the Voltage and SPI Mode
To run the Memory Starter Kit take these basic steps:
1. Power up the starter kit by connecting the board to the USB port of a computer.
2. Start the MPLAB program and select the Memory Starter Kit from the “Tools”
Once you have the board connected, select a device:
• Go to the Configure tool bar and the Select Device window will open. Select
• Next, Select the memory device from the Devices menu.
• Now you are ready to use the Memory Starter Kit.
• Install the device into the 16-pin socket on the board. Be sure to place all
• Read or write to the device by using the Read and Write icons on the top of the
The Memory Starter Kit includes a utility that will allow you to test the endurance of any
of the serial memory products that Microchip offers. By clicking on the Endurance
button, you may select a user defined pattern or select from one of the patterns
provided. When writing you have the ability to continuously write, read in between
cycles, or even alternate data patterns. The endurance utility will automatically stop
whenever a failure occurs.
“SEExxx” from the Device Family pull-down menu if it is not already selected.
Microwire devices in the upper half of the socket, all other devices including SPI,
I
GUI. These buttons work in conjunction with the “Read/Write options” pull-downs
on the upper left. You can write a pattern or the buffer contents to the array. Select
Entire Device or Selected Range for either writing or reading. Check the pull-down
menus before reading or writing to get the desired operation.
2
C, and UNI/O bus parts will go into the bottom half of the socket.
You should briefly see a pop-up balloon in the system tray (lower right of desktop)
that states (1) new hardware has been found, (2) drivers are being installed, and
(3) new hardware is ready for use. If you do not see these messages and then
the Memory Starter Kit does not work, try reconnecting the USB.
pull-down menu. You should then see “Memory Starter Kit connected” in the
output window.
SERIAL MEMORY PRODUCTS
MPLAB
®
STARTER KIT FOR
USER’S GUIDE
DS22087B-page 9