FS-9005 Digi International, FS-9005 Datasheet - Page 27

• Manufacturer Part Number: FS-9005
• Description: JTAG-BOOSTER FOR ARM7TDMI 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9005

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ARM7TDMI, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

/LENGTH=hhhhhh
The number of programmed bytes may be limited to LENGTH. If no LENGTH is
specified the whole file is programmed.
Default:
Abbreviation:
/NODUMP
In case of a verify error the contents of the flash memory is written to a file with
the extension .DMP. With /NODUMP you can suppress this feature.
/ERASEALL
Erase the whole flash device. If this option isn't set, only those blocks are erased
where new data should be written to.
/NOERASE
This option prevents the flash device from being erased.
/NORAM
To speed up the programming performance the flash programming algorithm is
loaded into target RAM, when the keyword RAM_BASE is specified in the
configuration file. If there are problems during programming, you should avoid
using the RAM by adding this option.
/FAST /FAST=
If you specify the option /FAST the host sends the data to be programmed to
the target without polling the status of the communication interface. This
increases the programming performance dramatically. But, when the target is
slow or the host is very fast, this can result in a data lost and the program aborts
with the message: "Target out of Sync. Try again". You can overcome this
problem by using the option /FAST= which does add some extra delay before
sending the next programming data to the target.
Examples:
JTAGARM7 /P ROMDOS.ROM /L=20000
This example programs up to 128 Kbytes of the file ROMDOS.ROM (with i.e.
512 Kbytes) to the bottom of the flash memory.
JTAG_ARM7TDMIa.doc
/LENGTH=4000000 (64 MByte)
/L=
27