G32A-A450-VD-2 DC12-24 Omron, G32A-A450-VD-2 DC12-24 Datasheet - Page 5

• Manufacturer Part Number: G32A-A450-VD-2 DC12-24
• Description: CARTRIDGE POWER DEVICE FOR G3PA
• Manufacturer: Omron
• Series: G3PAr

Specifications of G32A-A450-VD-2 DC12-24

• Accessory Type: Power Device Cartridge
• For Use With/related Products: G3PA Series
• For Use With: G3PA-450B-VD-2DC12-24 - RELAY SSR PHASE 200-480VAC 50A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Color: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: G32A-A450-VD-2DC12-24; G32AA450VD2DC1224

■ Replacement Procedure
G32A-A10(L)-VD/G32A-A20(L)-VD/G32-A420-VD(-2)
Use the special tool (provided) to extract the cartridge for replacement with a new one.
Extraction
Follow the procedures below to remove the Power Device Cartridge
from the G3PA.
1. Switch off the power.
2. Remove the terminal cover.
3. Hook the indented part of the cartridge with the tool (supplied with
Installation
Follow the procedures below to Install the Power Device Cartridge on
the G3PA.
1. Apply silicone grease (provided with the G32A-A) to the entire
G32A-A40(L)-VD/G32A-A60(L)-VD/G32A-A430-VD(-2)/G32A-A450-VD-2
The G32A Power Device Cartridge is mounted and secured with screws to the G3PA Unit.
Extraction
Follow the procedures below to remove the G32A-A Power Device
Cartridge from the G3PA.
1. Switch off the power.
2. Remove the terminal cover.
3. Loosen the two centered screws on the sides to dismount the car-
4. Loosen the screws on both the corners.
5. Hold the indented part of both the corners to remove
a new cartridge) and pull up on the cartridge to remove it.
surface of the heat sink.
tridge. The screws are connected to terminals 1 and 2.
the cartridge.
Loosen
Hook here with
Remover.
Loosen
Remover
Loosen
Loosen
2. Make sure that there is no dust or pieces of wire on the heat sink
3. Insert the cartridge into the opening of the G3PA so that the let-
4. Attach the terminal cover.
5. Switch on the power and check the G3PA to be sure it works
Installation
Follow the procedures below to Install the Power Device Cartridge on
the G3PA.
1. Apply silicone grease to the entire surface of the heat sink.
2. Make sure that there is no dust or pieces of wire on the heat sink
of the G32A-A or the G3PA.
ters on the cartridge and those on the G3PA are in the same
direction and side A and side B are even.
properly.
of the G32A-A or the G3PA.
Solid State Relays
Side A
Apply silicone grease here.
Apply silicone grease here.
G3PA
Side B
441