S202S02F Sharp Microelectronics, S202S02F Datasheet - Page 9

• Manufacturer Part Number: S202S02F
• Description: RELAY SSR 240VAC 8A ZC 4-SIP
• Manufacturer: Sharp Microelectronics
• Series: S202r

Specifications of S202S02F

• Circuit: SPST-NO (1 Form A)
• Output Type: AC, Zero Cross
• Load Current: 8A
• Voltage - Input: 1.2VDC
• Voltage - Load: 0 ~ 240 V
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Package / Case: 4-SIP
• Load Voltage Rating: 35 V
• Mounting Style: PCB
• Relay Type: Solid State
• Load Voltage Range: 80V To 240V
• Switching Mode: Zero Cross
• Relay Terminals: Through Hole
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• On-state Resistance: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 425-2403-5

● Degradation
● Standard Circuit
✩ For additional design assistance, please review our corresponding Optoelectronic Application Notes.
(a) Make sure there are no warps or bumps on the heat sink, insulation sheet and device surface.
(b) Make sure there are no metal dusts or burrs attached onto the heat sink, insulation sheet and device sur-
(c) Make sure silicone grease is evenly spread out on the heat sink, insulation sheet and device surface.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with rectangu-
lar waveform and this results may not make a device turn off.
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
face.
+V
V
CC
1
Tr1
R
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
1
D
1
3
4
S102S02
S202S02
SSR
1
2
Z
Z
S
9
S
: Surge absorption circuit (Snubber circuit)
Load
4.4mm MIN.
AC Line
S102S02 Series
S202S02 Series
Sheet No.: D4-A02401EN