5809A Pomona Electronics, 5809A Datasheet - Page 3
![OSCILLOSCOPE PROBE 10:1 RATIO](/photos/27/73/277326/4436210_sml.jpg)
5809A
Manufacturer Part Number
5809A
Description
OSCILLOSCOPE PROBE 10:1 RATIO
Manufacturer
Pomona Electronics
Type
Passiver
Specifications of 5809A
Attenuation Value
10:1
Bandwidth
300MHz (System)
Resistance - Input
10M
Voltage - Max
CAT I 300V
Capacitance - Input
17pF
Cable Length
47.244" (1200.00mm)
Color
Black
Includes
BNC Adapter, Ground Lead with Alligator Clip, Hook Tip (Retractable), IC Adapter, Insulating Tip, Trimmer Tool
Equipment Type
Passive Oscilloscope Probe
Impedance
10 M Ohms
Voltage Rating
300 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
na, Lead free / RoHS Compliant
Pomona
Low Frequency Trimmer Adjustment:
(Model 5800A is not adjustable)
Low frequency response can be matched to the oscilloscope by adjusting the compensation trimmer on
the head of the probe.
1.) Connect the probe to the oscilloscope and to a 1 KHz. Square wave source, the rise time should not
2.) Set the oscilloscope to display two to three cycles and two to six vertical divisions.
3.) Carefully adjust the trimmer tool to obtain the flattest tops to the square waves displayed on the
High Frequency Trimmer Adjustment:
(Models 5809A and 5812A only)
The high frequency compensation has been preadjusted at the factory, however if adjustment is required,
use the following procedure.
1.) Remove the compensation box cover located near the connector. Using the BNC adapter, connect
2.) Readjust the low frequency compensation if necessary.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
6/9/99
SY/EH/LS
S:\Engineering \Release\DataSheets\FlukeDataSheet\d4550B-SP150B_6_01.doc
exceed 10 microseconds (most oscilloscopes provide a probe compensation output). For X1/X10
probes, switch to the X10 position.
oscilloscope, see illustrations.
the probe to a square wave generator operating between 10 to 100 KHz terminated into 50 ohms.
The square wave generator rise time should be approximately .125 ns. Adjust each control until the
leading edge of the waveform is as flat, square and horizontal as possible (see high frequency
illustrations).
Sales: 800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
®
General Purpose Passive Oscilloscope Probes
Models 4550B, 5795A, 5800A, 5803A, 5806A,
5827A, 6049A, 6069A, 6265, 6266, SP150B
PomonaACCESS 90474 (800) 444-6785 or (425) 446-6010
More drawings available at www.pomonaelectronics.com
Page 3 of 6
Made in USA