1. INTRODUCTION
PRO-CRIMPER III Hand Tool Assembly 58573-1
consists of PRO-CRIMPER III Hand Tool Frame
354940-1 and Die Assembly 58573-2. The tool
assembly is used to crimp the spare wire caps listed in
Figure 1 onto single unstripped wire with thin copper
insert and with or without a moisture-resistant inhibitor.
Read these instructions thoroughly before using the
tool assembly.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or prototyping in
industrial, commercial, or institutional applications. Product crimped with this tool will
meet the crimp height requirement for hand tools in the appropriate Application
Specification (114-series), but may not comply with other feature parameters of the
specification. TE offers a variety of tools to satisfy your performance requirements.
For additional information, contact the Tooling Assistance Center at 1-800-722-1111.
DIE ASSEMBLY
NOTE
i
58573-2
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
CRIMPING CHAMBER
DIE ASSEMBLY
Moving Jaw
Die Assembly
MARKING
Die Retaining Screw
(2 Places)
Stationary Jaw
W
R
B
Y
Ratchet Adjustment
Wheel
PRO-CRIMPER* III Hand Crimping
Tool Assembly 58573-1 with
Die Assembly 58573-2
1.22-1.91 [.048-.075]
2.03-2.92 [.080-.115]
3.05-3.68 [.120-.145]
3.81-5.33 [.150-.210]
DIAMETER RANGE
WIRE INSULATION
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
(mm [in.])
Figure 1
For additional information on the hand tool frame, refer
to 408-9930.
Reasons for reissue of this instruction sheet are
provided in Section 8, REVISION SUMMARY.
2. DESCRIPTION
The tool consist of a stationary jaw and handle, a
moving jaw and handle, and an adjustable ratchet that
ensures full crimping. The tool features a ratchet
adjustment wheel for adjusting the crimp height.
The die assembly consists of an indenter (stationary
die) and an anvil (moving die). When closed, the dies
form four crimping chambers. Each die is held in the
tool frame by a single screw.
Standard
324484
324485
324486
324487
Pivot Pin
SPARE WIRE CAP
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
Moisture Resistant
(See Figure 1)
Back of Tool Frame
(Wire Side)
Ratchet
324693
324694
324695
324696
PRO-CRIMPER III Hand Tool
Frame 354940-1 (408-9930)
Moving Handle
Stationary Handle
Instruction Sheet
SPARE WIRE CAP
408-4251
COLOR CODE
21 APR 11 Rev F
Yellow
White
Blue
Red
1 of 4
LOC B