576778 Tyco Electronics, 576778 Datasheet - Page 2

• Manufacturer Part Number: 576778
• Description: TOOL HAND HVY HD STRATO 22-24AWG
• Manufacturer: Tyco Electronics

Specifications of 576778

• For Use With/related Products: 22-24 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Tool Type: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3. CRIMPING PROCEDURE
Refer to Figure 3 and the following steps for terminal
crimping procedures.
2
PIDG STRATO-THERM Terminal Crimping Tools
HAND TOOL
NUMBER
NOTE
1. Strip the wire to the dimension provided in
Figure 2, being careful to avoid nicking or
damaging the conductor(s).
PART
i
PIDG STRATO-THERM Terminals
Refer to Section 5 for information on the
insulation crimp adjustment.
(AWG)
WIRE
SIZE
Figure 3
CODE
DOT
DOT
HANDLE COLOR
HANDLE COLOR
CODE
Figure 2
TEMP.
HIGH
TERMINAL COLOR CODE
CAUTION
CAUTION
NOTE
2. Open the tool jaws by closing the tool handles
until the ratchet releases, then allow the handles to
open fully.
3. Place the terminal in the dies so that the wire
barrel butts against the locator.
4. Close the tool handles until the terminal is held
firmly in place. Do NOT deform the terminal.
5. Insert properly stripped wire into the terminal
until the end of the conductor butts against the
locator.
6. Complete the crimp by closing the tool handles
until the ratchet releases.
7. Release the tool handles, allow the handles to
open fully, and remove the crimped terminal.
8. Observe the dot code on the finished crimp to
ensure that the correct terminal and tool
combination was used. See Figure 2.
9. Refer to Section 4 and Figure 4 for terminal
crimp inspection procedure.
!
i
!
LOW TEMP.
Do NOT use wire with nicked or missing
conductors.
Make sure terminal insulation color code matches
tool handle color.
Do NOT allow wire insulation to enter the
terminal wire barrel.
Min.
STRIP LENGTH
408-10040
Max.
C