68321-1 Tyco Electronics, 68321-1 Datasheet - Page 5

• Manufacturer Part Number: 68321-1
• Description: TOOL HAND ROTA-CRIMP 6-10AWG
• Manufacturer: Tyco Electronics
• Series: 50 AMPr

Specifications of 68321-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: 6-10 AWG Terminals
• For Use With: 53880-4 - CONN TERM 6-10AWG CRIMP PWR LOCK
• Features: -
• Tool Type: -
• Lead Free Status / RoHS Status: na, Not applicable / Not applicable

If the crimping chamber conforms to the gage
inspection, the dies are considered dimensionally
correct and should be lubricated with a THIN coat of
any good SAE 20 motor oil. If the crimping chamber
does NOT conform to the gage inspection, the dies
must be returned for further evaluation and repair.
For additional information regarding the use of a plug
gage, refer to 408–7424.
6. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 10.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
Rev B
ROTA-CRIMP Crimping Tool 68321-1
5. In the same manner, try to insert the NO–GO
element into the crimping chamber. The NO–GO
element may enter partially, but must not pass
completely through the length of the crimping
chamber. See Figure 9.
Tyco Electronics Corporation
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
717–986–7605, or write to:
For repair service, contact a representative at
1–800–526–5136.
7. REVISION SUMMARY
Revisions to this instruction sheet include:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
S Updated document to corporate requirements
S Removed reference to company for plug gages
from Paragraph 5.2, C
408-2681
5 of 6