58509-1 Tyco Electronics, 58509-1 Datasheet - Page 2

• Manufacturer Part Number: 58509-1
• Description: DIE SET 22-10AWG BUDGET
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ III, Budgetr

Specifications of 58509-1

• Connector Type: Terminals and Splices
• Crimp Handle: A9996-ND
• Crimp Or Cable Size: 10-22 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: A31883

The die assembly features a wire anvil and a wire
crimper. Die retaining screws are used to secure the
dies in the tool frame.
3. INSTALLATION AND REMOVAL OF DIE SET
2
PRO-CRIMPER III Hand Crimping Tool Assembly 58508-1
22-16" Marking on
Crimping Section
of 5
1. Open the tool handles and remove the two die
retaining screws from the tool jaws.
2. Place the wire anvil so that the crimping section
marked “22–16” faces outward when mounted in
the stationary jaw of the tool frame.
3. Insert the die retaining screw through the jaw
and through the anvil, and tighten the screw just
enough to hold the anvil in place. Do not tighten
the screw completely at this time.
4. Place the wire crimper so that the crimping
section marked “22–16” faces outward when
mounted in the moving jaw of the tool frame.
5. Insert the die retaining screw through the jaw
and through the crimper, and tighten the screw just
enough to hold the crimper in place. Do not tighten
the screw completely at this time.
6. Carefully close the tool handles, making sure
that the anvil and crimper align properly. Continue
closing the tool handles until the ratchet in the tool
frame has engaged sufficiently to hold the anvil
and crimper in place, then tighten both die retaining
screws.
Wire Crimper
Wire Anvil
Tyco Electronics Corporation
(Figure 2)
Figure 2
4. CRIMPING PROCEDURE
Refer to the table in Figure 1 and select wire of the
specified size. Strip the wire to the length indicated in
Figure 1, taking care not to nick or cut wire strands.
Select an applicable terminal or butt splice and
identify the appropriate crimping section according to
the wire size markings on the dies. Proceed as
follows:
7. To disassemble, close the tool handles until the
ratchet releases, remove the two die retaining
screws and slide the anvil and crimper out of the
tool jaws.
NOTE
1. Squeeze tool handles together until the ratchet
releases and then allow the tool jaws to open fully.
2. Hold the tool so that the back (wire side) is
facing you. See Figure 3.
3. Holding the wire barrel, insert the terminal or
butt splice into the appropriate crimping section so
that the wire barrel seam faces the wire crimper
and the edge of the wire barrel is even with the
edge of the wire crimper.
i
This tool is provided with a crimp adjustment
feature. Initially, the crimp height should be
verified as specified in Figure 6. Refer to
Section 6, CRIMP HEIGHT INSPECTION, and
Section 7, RATCHET ADJUSTMENT, to verify
crimp height before using the tool to crimp
desired terminals or butt splices.
Tool Frame
Die Retaining
Screws
408-4372
Rev
B