1055781-1 Tyco Electronics, 1055781-1 Datasheet

no-image

1055781-1

Manufacturer Part Number
1055781-1
Description
TOOL HEX DIE SET A, B, C
Manufacturer
Tyco Electronics
Datasheet
1.1055780-1.pdf (2 pages)

Specifications of 1055781-1

Crimp Or Cable Size
55B. 58C, 141A, 142B,174, 174B, 178B, 187A, 188A, 196A, 223, 303, 316, 400
Product
Tool Component
Lead Free Status / RoHS Status
Not applicable / Not applicable
Connector Type
-
Crimp Handle
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
This instruction sheet contains the assembly
procedure for the SSMA Bulkhead Feedthrough
Cable Jack Connector shown in Figure 1. This
connector is a crimp attachment type connectors that
attaches to the cable listed in Figure 1.
The table in Figure 2 references the tooling used to
apply this connector. The table includes tool
descriptions, the Tyco Electronics part number, and
the corresponding (previous) part number.
Reasons for revision can be found in Section 4,
REVISION SUMMARY.
The SSMA Bulkhead Feedthrough Cable Jack
Connector consists of a housing assembly, a
dielectric, a center contact, an inner sleeve assembly,
E
i
Dimension on this sheet are in millimeters [with
inches in brackets], unless otherwise specified.
Figure 2
Figure 1
an outer sleeve, and a sheath (shrink tubing). See
Figure 1.
1. Place the outer sleeve and sheath on the cable.
2. Strip the cable according to the dimension in
Figure 3.
3. Flare the cable braid.
Follow safety precautions included with the tools
used for assembly.
To avoid personal injury, be sure to use
appropriate safety equipment, including gloves,
when using cable stripping tools.
Figure 3

1055781-1 Summary of contents

Page 1

... Figure 1. The table in Figure 2 references the tooling used to apply this connector. The table includes tool descriptions, the Tyco Electronics part number, and the corresponding (previous) part number. Figure 2 Dimension on this sheet are in millimeters [with inches in brackets], unless otherwise specified ...

Page 2

... Adherence to the preeding steps should yield the tolerances shown in Figure 7. Reference Plane 4. REVISION SUMMARY Since the previous release of this sheet: S Document format was updated to current corporate requirements. Tyco Electronics Corporation 408-4785 Sheath Inner Sleeve Figure 6 0.00-0.18 [.000-.007] Dielectrric 0.00-0.25 [.000-.010] ...