308210-3 Tyco Electronics, 308210-3 Datasheet - Page 2

• Manufacturer Part Number: 308210-3
• Description: INDENTER FOR DIE 68242-1
• Manufacturer: Tyco Electronics

Specifications of 308210-3

• Lead Free Status / RoHS Status: Not applicable / Not applicable

Note:
2
Crimping Die Assemblies for SOLISTRAND Terminals
DIE ASSEMBLY
SIZE RANGE
Figure 2
(AWG)
WIRE
STRIP LENGTH
ACCEPT
Crimp Inspection
Figure 3
3. CRIMPING PROCEDURE
For die installation, machine setup, and machine
operation, refer to the instructions packaged with the
machine. Use the appropriate wire size and strip
length according to Figure 2.
Inspect crimped terminals according to Figure 3. Use
only the terminals that meet the conditions shown in
the “ACCEPT” column. “REJECT” terminals can be
avoided by following the above procedures and by
performing regular die maintenance, as provided in
Section 4, MAINTENANCE AND INSPECTION.
4. MAINTENANCE AND INSPECTION
It is recommended that a maintenance and inspection
program be performed periodically to ensure
dependable and uniform terminations.
Note:
DANGER
REJECT
To avoid personal injury, disconnect machine
from power sources (air and electric) when
installing dies. Before operating machine, make
certain that all guards and protective covers are
in place.
408-2585
F