318452-2 Tyco Electronics, 318452-2 Datasheet - Page 3

• Manufacturer Part Number: 318452-2
• Description: PROCRIMP DIE ASSY COMM BNC
• Manufacturer: Tyco Electronics
• Type: Dier

Specifications of 318452-2

• Connector Type: BNC
• Crimp Handle: Tyco/AMP 318452-1
• Crimp Or Cable Size: Belden 9907, 89907, Comm/Scope 2104
• Product: Tool Component
• Description/function: BNC O Crimp Commercial
• Features: Die for Pro-Crimper
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With: 50 Ohm RF Connectors
• Other names: A24781

4.2. Ferrule
Rev
Center Contact Crimp
Center Contact
Flange Against
Edge of Die
Ferrule Crimp
PRO-CRIMPER III Hand Crimping Tool Assembly 318452-1
1. Flare the cable braid and insert the crimped
center contact into the connector body until the
cable dielectric is against the dielectric inside the
connector body. The flared braid will then fit over
the support sleeve of the connector body.
B
Anvil Die
Ferrule
Anvil Die
Stripped
Cable
(Figure 4)
Figure 3
Tyco Electronics Corporation
Figure 4
5. INSPECTION
5.1. Visual Inspection
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimping chambers for
flattened, chipped, worn, or broken areas. If damage
or abnormal wear is evident, the dies must be
replaced. See Section 8, DIE REPLACEMENT.
6. INSPECTION
6.1. Visual Inspection
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimping chambers for
flattened, chipped, worn, or broken areas. If damage
or abnormal wear is evident, the dies must be
replaced. See Section 8, DIE REPLACEMENT.
2. Slide the ferrule forward over the braid until the
ferrule is against the connector body.
3. Place the ferrule in the crimping chamber on the
anvil die so that the shoulder of the connector body
is against the edge of the die. Refer to Figure 4.
4. Holding the assembly in place, close the tool
handles until the ratchet releases.
5. Allow the handles to open fully, and remove the
crimped assembly from the die assembly.
Cross-Sectional
View
Connector Shoulder
Against Edge of Die
Anvil Die
408-4219
3
of 6